Install Decorative Door Panels - Norcold N611v Owner's Manual

- Make sure that the top edge of the baffle is
between 1/4 inch and 1/2 inch [213] below
the condenser and that there is 1/4 inch or
less clearance [15] between the rear of the
condenser and the baffle.
- For the best cooling performance, the
baffle should be 1/4 inch below the bottom
of the condenser.
- If the depth of the enclosure is more than 26 inches
[27], install a wood or an aluminum or galvanized
steel sheet solid box baffle [21] between the lower
intake vent and the upper exhaust vent (See
Art02526).
- Make sure that the solid box baffle is the full
width of the inside of the enclosure.
- Make sure that the bottom of the solid box
baffle is 18 inches to 18 1/2 inches above the
bottom of the enclosure [17].
- Make sure that the back of the solid box baffle
is perpendicular to the bottom of the enclosure.
- Make sure that the horizontal top of the solid
box baffle is even with the bottom edge of the
condenser [11].
- Make sure that the vertical top edge of the
baffle is between 1/4 inch and 1/2 inch [213]
below the condenser.
- Make sure that there is 1/4 inch or less
clearance [15] between the rear of the
condenser and the baffle.

Install Decorative Door Panels

The doors are made to accept decorative panels. The decorative panels must be 3/16 inch or less in thickness. Install
NOTICE
the decorative door panels in the refrigerator doors before installing the refrigerator in the vehicle.
- Make an upper door panel that is 21 19/32 inches wide x 14 17/32 inches high.
- Make a lower door panel that is:
- 21 19/32 inches wide and
- 31 5/8 inches high (for N611v models) or
- 38 5/8 inches high (for N811v models).
- Pull the panel retainer [37] off each door (See Art00965).
- Push the decorative door panel [38] into the slots of the door [39].
- Push each panel retainer into the slot on the edge of the door.
15 13 15
10
27
37
Installation and Owner's Manual 19
11
15
24
213
25
21
17
9
Art02426
39
38
Art00965