Norcold N610 Owner's Instructions

Owner - Please keep these instructions with your Owner's Manual for future reference.
These instructions describe a "cooling unit sensing" feature which may not have been in the original controls of your
refrigerator. Please use these instructions in addition to those in the "Operating the Refrigerator Controls" section your
Owner's Manual.
Operating the Refrigerator Controls - (N61X and N81X models)
Cooling unit sensing:
The controls have the ability to sense the operation of the cooling unit. If the controls sense that the cooling unit has stopped
cooling:
- The heat sources to the cooling unit are turned off and are locked out by the controls.
- The ON light flashes about five times every three seconds.
You can reset the controls and remove the fault code one time. To reset the controls, shut off and then start the refrigerator.
- To turn off the refrigerator, push the selector switch to the OFF position.
- To turn on the refrigerator, push the selector switch to the AUTO position.
If you reset the controls and the fault occurs again before the refrigerator completes a full cooling cycle:
- The heat sources to the cooling unit are turned off and are locked out.
- The ON light flashes about five times every three seconds.
- This time you can not reset the fault. Have the refrigerator serviced by your dealer or a Norcold authorized Service Center as
soon as possible.
Owner's Instructions -
"Cooling Unit Sensing"
Serviceman - Please give these instructions to the vehicle owner.
1
Part No. 623934A (11-02)