Memory Module - HP ProBook 4310s Maintenance And Service Manual

Removal and replacement procedures

Memory module

Description
2048-MB memory module (1333-MHz, DDR2)
1024-MB memory module (1333-MHz, DDR2)
Before removing the memory module, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on,
and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the memory/wireless module compartment cover (see
Remove the memory module:
✎
The top memory module slot is for expansion memory, and the bottom slot is for primary memory.
1. Pull away the retention clips 1 on each side of the memory module to release the memory module. (The
memory module tilts up.)
CAUTION: To prevent damage to the memory module, hold it by the edges only. Do not touch the components on the memory
Ä
module.
2. Grasp the edge of the memory module 2, and then pull it out of the memory module slot.
✎
Memory modules are designed with a notch 3 to prevent incorrect insertion into the memory
module slot.
Reverse this procedure to install a memory module.
4–16
"Battery" on page 4-7).
"WLAN module" on page
Maintenance and Service Guide
Spare part number
577197-001
577196-001
4-12).