Common Finishing; Charcoal Embers; Vermiculite; Logo Placement - Napoleon BGD36CFNTR Installation And Operating Instructions Manual

Vented natural and propane gas fireplace heaters
Table of Contents

Advertisement

COMMON FINISHING

GLOWING EMBERS
Tear the embers into pieces and place along the front row
of ports covering all of the burner area in front of the small
logs (#2 & #3). Care should be taken to shred the embers
into thin, small irregular pieces as only the exposed edges of
the fi bre hairs will glow. The ember material will only glow
when exposed to direct fl ame; however, care should be
taken to not block the burner ports.
Blocked burner ports can cause an incorrect fl ame pattern,
carbon deposits and delayed ignition. PHAZER
when exposed to direct fl ame. Use only certifi ed "glowing
embers" and PHAZER
TM
logs available from your Napoleon
dealer.

CHARCOAL EMBERS

Randomly place the charcoal embers along the front and
sides of the log support tray in a realistic manner. Fine dust
found in the bottom of the bag should not be used.

VERMICULITE

Sprinkle vermiculite around the charcoal embers.
Note: Both charcoal embers and vermiculite are not to
be placed on the burner.

LOGO PLACEMENT

½"
LOGO
½"

BGD36CF FINISHING

LOG PLACEMENT

PHAZER
TM
logs and glowing embers exclusive to Napoleon
Fireplaces, provide a unique and realistic glowing effect that is
different in every installation. Take the time to carefully position
the glowing embers for a maximum glowing effect.
Log colours may vary. During the initial use of the fi replace,
Log colours may vary. During the initial use of the fi replace
the colours will become more uniform as colour pigments burn
in during the heat activated curing process.
TM
logs glow
Remove the backing of the logo
supplied and place on the glass
viewing door, as indicated.
FIGURE 92
FIGURE 93
FIGURE 93
1. Place the back log (#1) onto the log
SIDEVIEW
support tray and in front of the tabs. The
tabs maintain an air space between the
log and fi rebox back to facilitate combus-
tion air fl ow. Ensure that the back of the
log rests against the brackets on the back
wall of the fi rebox.
TAB
FIGURE 94
2. Move the two small logs (#2 & #3) into position, lining
up the studs located on the burner with the holes on the
bottom of the logs. Ensure that the small logs sit fl at on the
burner.
3. Place the bottom of the left crossover log (#4) against
the left fi rebox side and pulled forward to the grate.
The top of the log should rest in the pocket on the back log.
4. Position the base end of the center log (#5) against the
middle grate post with the other end of the log resting in the
pocket of the left crossover log.
31
FIGURE 95
FIGURE 95
FIGURE 96
FIGURE 96
FIGURE 97
FIGURE 97
W415-0566 / D / 08.30.07

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bgd42cfnBgd42cfpBgd36cfptr

Table of Contents