Space Motor Assembly - Oki Microline 182 Maintenance Manual

3.2.8

Space motor assembly

Remove the upper cover (see 3.2.1).
Remove the print head (see 3.2.6).
Remove the ribbon feed gear assembly (see 3.2.7).
Remove connector 0, and observe concave surface.
Remove three screws 0.
Remove space motor assembly 0.
For reassembly, reverse the disassembly procedure.
Notes:
Do not touch the space motor assembly @ terminal (contact) @ direcfly with hand
and make sure that if is clean.
When installing space motor assembly 0, put the @ side of the assembly close to
2.
carriage frame @, and align the @ side of the assembly with the corresponding side
of the carriage frame.
When installing slider 0, put the @ and @parts of the slider close to space motor
3.
assembly 0.
4.
and print head (see section 5).
3 - 1 6