License Plate Lamp - Chevrolet 2013 Malibu Owner's Manual

Notice: Improper lamp assembly
removal and installation can
cause leaks and water intrusion
which may cause damage to the
taillamp. Do not remove the
taillamp assembly to replace a
bulb. Use the trunk opening to
access the bulb.
The stoplamp/taillamp is an LED. To
replace the stoplamp/taillamp see
your dealer.
Turn Signal Lamp
1. Open the trunk. See Trunk on
page 2 11.
2. Remove the push pins and pull
the trunk trim away from the
taillamp assembly.
3. Remove the bulb socket from
the taillamp assembly by turning
it counterclockwise.
4. Remove the bulb from the
socket by turning the bulb
counterclockwise one-quarter
turn and pulling it straight out.
5. Install a new bulb into the
socket.
6. Install the bulb socket into the
taillamp assembly by turning it
clockwise.
7. Install the trunk trim and
push pins.
Vehicle Care

License Plate Lamp

To replace one of these bulbs:
Passenger Side Shown, Driver
Side Similar
1. Push the release tab toward the
lamp assembly.
2. Pull the lamp assembly down to
remove.
10-35