Step 22: Replace Floor Protect; Step 24: Replace Toekick - GE Built-In Dishwasher Installation Instructions Manual

Dishwasher Installation

STEP 22: REPLACE FLOOR PROTECT

(on some models)
• Slide Floor Protect under dishwasher.
• Angle the rear back edge of the Floor Protect upwards to
engage mounting tabs.
• Lift front of drip tray and secure with 2 screws.
• Secure leak sensor to front of Floor Protect with 1 screw.
Figure AE
STEP 23: POSITION SOUND BARRIER
AND INSULATION (on some models)
Skip this step if the sound barrier is not assembled to the
dishwasher.
• Locate the sound insulation package inside the dishwasher.
• Locate the control box.
Figure AF
• Apply the insulation to the underside of the control box and
Figure AG
Insulation shown adhered to bottom edge of the control
box, flush with the front face, and correctly placed along
dishwasher bottom.
• Remove the masking tape from the sound barrier, and door
front. Re-position the sound barrier over the sound insulation.

STEP 24: REPLACE TOEKICK

• Place toekick against the legs of the dishwasher.
Floor Protect
Control
Figure AH
Box
• Align the toekick with the bottom edge and make sure it is
• Insert and tighten the 2 toekick attachment screws. The
• When reinstalling the toe kick on models with a sound barrier,
ensure that the bottom edge of the rubberized flap is flush
with the floor. Any excess material should be tucked up
behind the outer door. Do not allow excess rubberized flap to
lay on the floor. If any excess is not tucked completely behind
the outer door, it will bunch up between the door and toe kick
and impede proper opening and closing of the door. This will
be noticeable because the door will not stay fully open and
will spring up.
Tip: Reduce sound from under the dishwasher. Make sure
toekick is against floor.
STEP 25: LITERATURE
• Be sure to leave complete literature package, these
Installation Instructions and product samples and/or coupons
with the consumer.
T o e k i c k
Attachment
Screws
Sound
Barrier
13