Table of Contents
Advertisement
Auto Continue Setting
When Auto Continue is enabled, the printer will automatically print the
next received data following a preset amount of time passes after any one
of the following errors occurs:
Memory overflow Press GO
Print overrun Press GO
KPDL error Press GO
File not found Press GO
Hard disk err Press GO
RAM disk error Press GO
MemoryCard err Press GO
Duplex disabled Press GO
If one of the above errors is caused by someone on a network where the
printer is being shared, for example, data sent from another person will be
printed after a preset amount of time.
1
Press the MENU key.
2
Press the
or
Others
3
Press the > key.
4
Press the
or
>Auto Continue >
Mode
On
5
Press the ENTER key. A blinking question mark (?) appears.
>Auto Continue
Mode ? On
6
Select On or Off using the
7
Press the ENTER key.
8
Press the MENU key. The message display returns to Ready.
1-105
key repeatedly until Others > appears.
>
key repeatedly until Auto Continue > appears.
or
key.
Configuration
Advertisement
Table of Contents
