Fan Speed - Carrier 42ADF025 Owner's Manual

42ADF025, 42ADF035
Use of the Remote Control
Powerful (button F)
If you want more powerful capacity at Cooling, Dry and Heating
mode, press button . On the display, the powerful icon
start flashing.
1. Powerful at Cooling mode
Performs the powerful cooling operation
until room temperature reach 17°C or 20
minutes after pressing Powerful button. At
this mode, indoor fan speed is high and
compressor speed is over rating speed in
order to obtain maximum cooling capacity.
2. Powerful at Heating mode
Performs the powerful heating operation
until room temperature reach 32°C or 20
minutes after pressing Powerful button. At
this mode, indoor fan speed is high and
compressor speed is over rating speed in
order to obtain maximum heating capacity.
3. Powerful at Dry mode
Performs the effective dry operation until
room temperature in under 17°C or 3 hours
after pressing Powerful button. At this
mode, indoor fan speed is low in order to
remove humidity more effectively.
During Powerful mode, you cannot control room temperature, and

fan speed.

Press one of the buttons .
Economical E (button G)
If you want economical operation at cooling, heating and Auto
mode, press button E On the display, the economical icon E will
start flashing.
1. Economical at Cooling
mode
Automatically controls the room
temperature, fan speed and operation to
save energy.
1. Press E: Start and stop the operation
2. Economical at Heating
mode
Automatically controls the room
temperature, fan speed and operation to
save energy.
1. Press E: Start and stop the operation
3. Economical at Auto mode
Unit operates Economical cooling mode or
Economical heating mode depending on
room temperature.
During Economical mode, you can control room temperature and
flap position except fan speed.
Press one of the buttons .
Note: Under certain conditions, Economical mode may not provide
adequate heating or cooling due to energy saving features.
will
or E to cancel the powerful mode.
or E to cancel.
ON timer procedure
1. ON TIMER button
(button I)
Press this button, even if the remote
control is OFF. The relevant icon and time
figure will start to flash. If 10 seconds have
elapsed and no button is pressed, the
remote control turns OFF (if it was already
OFF when button
function automatically deactivates.
2. HOUR/MINUTE buttons
(buttons
If the unit is ON, the only possible selection
is the start-up time. The unit will operate
with the selections shown on the display.
3. HOUR/MINUTE buttons
(buttons
If the unit is OFF: to select the start-up
time, use the temperature cotrol buttons
(buttons
First select the hours and, afrer have
confirmed these by pressing button
select the minutes using either button
or .
To definitively set the time, press button
again.
4. Operating mode
Choose the unit operating mode. The
icons will flash. To select the mode, use
the button
decided, press button
selected mode will stop flashing.
5. Desired temperature
To select the desired temperature, (the
value is flashing, use either button
Push button
Numbers will stop flashing.
6. Fan speed
Choose the fan speed, using button
. When the selection has been completed,
press button
will stop flashing.
7. Louvre positioning
Now this icon is flashing.
Use button
Press button
Now all icons are fixed on display.
If you want to cancel selections up to here
inserted, push button
cancel all options once timer has been set,
push button
GB
E N G L I S H
was pressed) or timer
and )
and )
and ).
,
. Once the mode has been
. The icon of the
or
, to confirm the selection.
for confirmation. The icon
, to select desired position.
for confirmation.
; if you want to
and then .
.
11