Battery Installation And Removal; Remote Control-Only Functions - Krell Industries Showcase DVD Player Instructions For Use Manual

Remote Control Description
See Figure 2 on page 8
Battery Installation
and Removal
Notes
Remote
Control-Only
Functions
ADVANCED DISC
FUNCTIONS
12
The Showcase DVD remote control uses one CR2025 lithium bat-
tery, which is included with the shipment.
To open the battery compartment on the back of the remote control:
1. Place the remote face down on the table.
2. Use your thumbnail or a small jeweler's or eyeglass screwdriver
to move the small tab toward the center of the remote, while
using your index fingernail or screwdriver to pull down gently on
the slot to the right of the tab. The battery compartment will slide
out.
3. Place the battery, positive (+) side up, in the battery tray.
4. Slide battery compartment back into the remote until you hear a
click.
The remote control is ready for operation.
Do not use a knife or other sharp object to open the battery compartment;
they will scratch the remote control finish.
Replace batteries when remote control function becomes intermittent.
Remove batteries if the remote control is not used for a long time. Battery
leakage can damage the remote control.
The Showcase DVD remote control provides all the power, standard
disc functions, menu access, and menu setup functions available on
the front panel. Additional advanced disc and programming functions
are accessed only from the remote control. A description of the
remote control-only keys for the Showcase DVD follows.
20 Audio Key
Press this key to access the audio icon on the multiple-toolbar
menu. Use the down directional button or key (14) to cycle
between or the languages available on the disc soundtrack.
OFF
The last language scrolled to is automatically selected, and
becomes active after the transport (12) is opened and closed.
Navigate to the audio sound category of the
expanded view of the languages available.
menu for an
OSD
Krell Showcase DVD