Install The Transceivers; Configure The Workstation; Configuring The Workstation Ip Address For Ethernet Connections; Configuring The Workstation Serial Port - HP StorageWorks SN6000 Installation And Reference Manual

Install the transceivers

A small form-factor pluggable (SFP) transceiver is required for each switch port connected to a device or
another switch. SFPs are not included with the switch. An XPAK transceiver is required for each switch 10
Gb/s port connected to the 10 Gb/s port of another switch. Only HP transceivers are supported for use in
the switch. To install an transceiver, insert the transceiver into any of the active switch ports and gently press
until it snaps in place. To remove a transceiver, gently press the transceiver into the port to release the
tension, then pull on the release tab or lever and remove the transceiver.
TIP: The transceiver fits only one way. If the transceiver is not installed under gentle pressure, invert it and
try again. A new switch has all ports active.

Configure the workstation

NOTE: If you plan to use Simple SAN Connection Manager or QuickTools to manage the switch,
proceed to "Apply power to the
If you plan to use the CLI to configure and manage the switch, you must configure the workstation. This
involves setting the workstation IP address for Ethernet connections, or configuring the workstation serial
port.

Configuring the workstation IP address for Ethernet connections

The default IP address of a new switch is 10.0.0.1. To ensure that your workstation is configured to
communicate with the 10.0.0 subnet:
• For a Windows workstation:
a. Click Start, then choose Settings > Control Panel > Network and Dial-Up Connections.
b. Choose Make New Connection.
c. Click the Connect to a private network through the Internet radio button, then click Next.
d. Enter 10.0.0.253 for the IP address.
• For a Linux workstation, open a command window and enter the following command where
interface is your interface name:
ifconfig interface ipaddress 10.0.0.253 netmask 255.255.255.0 up

Configuring the workstation serial port

To configure the workstation serial port:
1. Connect a null modem F/F DB9 cable from a COM port on the workstation to the RS-232 serial port on
the switch.
2. Configure the workstation serial port according to your platform:
For a Windows workstation:
a. Open the HyperTerminal application. Click Start, then select Programs > Accessories >
Communications > HyperTerminal.
b. Enter a name for the switch connection and choose an icon in the Connection Description window.
Click OK.
c. Enter the following COM Port settings in the COM Properties window, and click OK.
• Bits per second: 9,600
• Data Bits: 8
• Parity: None
• Stop Bits: 1
• Flow Control: None
switch" on page 40.
HP StorageWorks SN6000 Fibre Channel Switch Installation and Reference Guide 39