SOYO SY-6ILA User Manual page 25

Hardware Setup
Step 17. Power Button Enable (JP8)
Your system can be power on by either pressing a power button or
typing in a password, which can be set in the BIOS SOYO COMBO
Setup. To avoid being unable to power up the system due to of
forgetting the password, you can place a jumper cap to short JP8.
This will always enable the Power Button.
Power Button
Enable
JP8 Setting
Step 18. Power On
You have now completed the hardware installation of your
Motherboard successfully.
1. Turn the power on
2. To enter the BIOS Setup Utility, press the <DEL> key while the
system is performing the diagnostic checks,
Note: If you have failed to enter the BIOS, wait until the boot
up sequence is completed. Then push the RESET button and
press <DEL> key again at the beginning of boot-up, during
diagnostic checks.
Power Button always
enabled
Short pin to
always enable
the Power
Button.
according to BIOS
Open pin for a
Power Button
function according
to the BIOS
setting.
22
SY-6ILA
Power Button
setting