Table of Contents
Advertisement
Hardware Setup
Step 15. CMOS Clearing (JP5)
After you have turned off your computer, clear the CMOS memory
by momentarily shorting pins 2-3 on jumper JP5, for a few seconds.
Then restore JP5 to the initial 1-2 jumper setting in order to recover
and retain the default settings.
After you have turned off your computer, clear the CMOS memory by
momentarily shorting pin 2-3 on jumper JP5 for at least 5 seconds. Then
permanently short pin 1-2 to retain new settings.
Jumper JP5 can be easily identified by its white colored cap.
CMOS
Clearing
Short pin 2-3 for
JP5
at least 5 seconds
Setting
to clear the CMOS
Note: You must unplug the ATX power cable from the ATX power
connector when performing the CMOS Clear operation.
Step 16. Onboard Sound Jumper (JP7)
The onboard audio features of your Motherboard are controlled by
jumper JP7. You can choose to enable or disable the available
sound function by setting JP7 accordingly.
l
Short pin 1-2 on jumper JP7 to enable the onboard sound function.
Then, you can plug your external audio devices such as amplified-
speakers, CD-player, and microphone to the Motherboard Line-out,
Line-in and Mic ports right after the Motherboard is installed. (You
do not need to install any sound card.)
l
To disable the onboard sound options short pin 2-3 on jumper JP7.
Onboard
Sound
JP7 Setting
Clear CMOS Data
Disable
Short pin 2-3
to disable the
onboard sound
function.
Retain CMOS Data
Short pin 1-2
3
to retain new
2
settings
1
Short pin 1-2
3
to enable the
2
onboard sound
1
function.
21
SY-6ILA
3
2
1
Enable
3
2
1
Advertisement
Table of Contents
