SOYO SY-6ILA User Manual page 22

Hardware Setup
Warning: Follow these precautions to preserve your
Motherboard from any remnant currents when connecting
to ATX power supply:
Turn off the power supply and unplug the power cord
of the ATX power supply before connecting to ATX PW
connector.
The Motherboard requires a power supply with at least 200 Watts
and a "power good" signal. Make sure the ATX power supply can
take at least 720 mA * load on the 5V Standby lead (5VSB) to meet
the standard ATX specification.
* Note: If you use the Wake-On-LAN (WOL) function, make sure the
ATX power supply can support at least 720 mA on the 5V Standby
lead (5VSB).
Please install the ATX power according to the following pin
assignment:
ATX Power
12V 5V
5VSB 5V
PW-0K -5V
GND GND
5V GND
GND GND
5V PS-ON
GND GND
3.3V -12V
3.3V 3.3V
Ø
Pay special care to the directionality.
19
SY-6ILA