Pride Mobility Destiny Owner's Manual page 32

V I I I . D I S A S S E M B L Y
ASSEMBLY
To assemble the scooter:
1. Position the front and rear sections of your scooter as
shown in figure 15.
2. Align the locking brackets on the rear section with the
corresponding pegs on the front section.
3. Using the seat post, slowly pivot the rear section forward
until the locking brackets are fully connected to the pegs.
4. Reinstall the frame lock pin.
5. Raise the tiller.
6. Reinstall the batteries and tighten the battery straps.
7. Reconnect the battery cable connectors until the locking
tab engages, indicated by a "click."
8. Reconnect the front-to-rear harness.
9. Reinstall the rear shroud.
10. Reinstall the upper seat post and secure it with the ball
detent pin.
11. Reinstall the seat and rotate it into place, then reinstall and
tighten the securement knob.
Figure 15. Frame Positioning
32
www.pridemobility.com
A N D A S S E M B L Y
FRAME LOCK PIN
LOCKING BRACKET
Figure 14. Frame Separation
PEG
Destiny