Charcoal Embers; L334 Louvre Installation - Napoleon GD33NR Installation And Operating Instructions Manual

24
C
Position the notch located in the bottom end of log #3 against
the centre grate post. Rest the top of log #3 into the pocket
at the top end of log #2.
NOTE: There are 2 extra logs included in this GL-638 log set. These small charcoal logs (part#W135-0082 and
W135-0182) are not meant for use in the BGD33. For these models these two logs must be discarded.
Tear the glowing embers into pieces and place onto the small carry
ports. Care should be taken to shred the embers into thin, small ir-
regular pieces as only the exposed edges of the fi bre hairs will glow
when exposed to direct fl ame; however care should be taken to not
block the burner ports. Blocked ports can cause an incorrect fl ame
pattern, carbon deposits and delayed ignition.
Randomly place the charcoal embers behind the grate posts and around the logs in a realistic manner but not in contact with
the fl ames. Keep ember dust away from burner ports to avoid plugging them.
FIGURE 51
B
C
Note: The protective wrap is best removed from the louvres when the assembly is at room temperature but this
can be improved if the assembly is warmed, using a hair dryer or similar heat source.
W415-0662 / A / 03.04.09
GLOWING EMBERS

CHARCOAL EMBERS

L334 LOUVRE INSTALLATION

A
D
Place the bottom of log #4 onto the locating pin on the right
side of the log support. Rest the top into the pocket provided
on the center log (#3).
FIGURE 47
SMALL CARRY PORTS
FIGURES 52 a,b&c
A
CLIPS
FLANGE
CENTRE
SLOT
SLOT
TAB
B
C
HINGE
SLOT
CLIP
SMALL CARRY PORTS
HOOD
Attach the hood by pressing the
top fl ange into the clips along
the top of the louvre opening.
Secure using a screw through
the centre slot.
NOTE: Hood W335-0028 is
required on all models.
UPPER LOUVRES
Insert the louvre tabs into the
slots located at the top left and
right corners of the unit.
LOWER LOUVRES
Insert the hinge clips into the
slots located at the bottom left
and right corners of the unit.
To remove the louvres, pull the
back tabs of the clips forward,
while pushing the louvre assem-
bly back. Lift the clip.