Stamina 1773 Owner's Manual page 9

ASSEMBLY INSTRUCTIONS
LEFT
STEP 6
1. There is an "L" decal on the LEFT PEDAL ARM(4), and an "R" decal on the RIGHT PEDAL ARM(5).
NOTE:
2. The RIGHT PEDAL SHAFT(42) has right hand threads and is tightened by turning clockwise.
The LEFT PEDAL SHAFT(41) has left hand threads and is tightened by turning counterclockwise.
Place the front end of the RIGHT PEDAL ARM(5) on the ROLLER(58) of the FRONT STABILIZER(2).
Connect the back end of the RIGHT PEDAL ARM(5) to the RIGHT CRANK(36). Thread the RIGHT PEDAL
SHAFT(42) into the RIGHT CRANK(36) by hand. SECURELY TIGHTEN using a 15mm open-ended wrench
or an adjustable wrench (not included). Repeat on the left side.
should be in contact with the CRANK(35, 36) when securely tightened.
Check the tightness of the PEDAL SHAFT(41, 42) and CRANK(35, 36) regularly. Retighten as necessary.
The PEDAL SHAFT(41, 42) must be securely tightened to the CRANK(35, 36).
Failure to securely tighten may cause the PEDAL SHAFT(41, 42) to become loose
from the CRANK(35, 36) and may result in serious injury to user and damage to
product. The shoulder of the PEDAL SHAFT(41, 42) should be in contact with the
CRANK(35, 36) when securely tightened.
STEP 7:
There is an "L" decal on the LEFT PEDAL CAP(46), and an "R" decal on the RIGHT PEDAL
CAP(47). Attach the RIGHT PEDAL CAP(47) to the RIGHT PEDAL ARM(5) with ROUND HEAD SCREWS
(M5x15mm)(75). Repeat on the left side.
The LEFT and RIGHT PEDAL CAPS(46, 47) have a raised lip on three sides. Attach the LEFT and
NOTE:
RIGHT PEDAL CAPS(46, 47) to the LEFT and RIGHT PEDAL ARMS(4, 5) so that the side without
the raised lip is on the outside.
L
L
WARNING!
9
The shoulder of the PEDAL SHAFT(41, 42)
R
R
RIGHT