Front Panel Information Display - Harman Kardon AVR80II Owner's Manual

¡
"Visual" Indicator: These indica-
tors display which input source is
being fed to the video monitor output.
™
Test: This indicator flashes when
the output levels are being set using
the built in test signal generator.
£
Memo: This indicator flashes
when the Memo button is pressed
when entering presets and other
information into the tuner's memory.
¢
Auto: This indicator signifies that
the Automatic Tuning mode is in use
for FM broadcasts.
∞
Tuned: This indicator lights when
an AM or FM station is properly
tuned and locked.
§
Stereo: This indicator lights
when an FM station is broadcasting
in stereo.
¶
Volume indication: The last two
indicators on the information display
indicate the volume level. Note that
is the reference level, not an
0dB
indication that there is no output.

Front Panel Information Display

•
Tuner Frequency Indication:
When the tuner is in use, the main
Information Display will show the
preset channel number, if any, the
frequency band and the station fre-
quency. Indicators at the right side
of the display show
station is tuned or
station is tuned.
ª
Main Information Display: This
ten digit display shows messages
relating to the status, input source,
surround mode, tuner, volume level
or other aspects of unit's operation.
‚
Multi: This indicator signifies that
the AVR80 is sending a program
II
source to a remote room location.
Note that it may be illuminated even
when the unit is "off" in the main lis-
tening room, signifying that opera-
tion continues at another location.
When a remote command is being
received via the Multi IR connection,
this indicator will flash.
⁄
Mode Status: These indicators
display the currently selected
surround mode.
¤
DISP: This indicator lights when
the FL display has been turned
off using the Display button ) to
remind you that the unit is still
turned on.
7
when an AM
kHz
when an FM
MHz
‹
Copy Indicators: The
indicator lights when an input
COPY
other than the current source has
been selected to copy Tape 1. The
indicator signifies that
VCR COPY1
the input to VCR 1 is other than the
currently selected source.
›
P-Scan: This indicator flashes
when the stations programmed into
the tuner memory are being auto-
matically reviewed.
fi
Auto Memo: This indicator flash-
es when the tuner is automatically
scanning for stations and entering
them into the preset memory.
fl
Signal Level Indication: This is
a visual indication of the strength of
a radio station signal. The more bars
visible, the stronger the station.
TAPE