Table of Contents
Advertisement
Registration and deregistration
Adding and registering handsets
Register a handset to your telephone base
for AT&T models TL96271/TL96371/TL96471
1. Make sure the handset is out of the telephone
base or charger and shows Put handset on
BASE to register before you begin registration.
2. Put the handset you wish to register on the
telephone base cradle, not the charger.
3. The handset displays Registering handset...,
and the telephone base screen displays
Registering... Please wait. It takes about 90
seconds to complete the registration process.
The handset displays HANDSET X Registered
(X represents the registered handset number),
and beeps when registration completes.
If registration fails, the system will
automatically try to register again. If it fails
after the third try, the handset displays
Registration failed, then Put handset on
BASE to register. The telephone base screen
displays Registration failed and then returns
to the idle screen. This may take up to five
minutes to occur. When the handset displays
Put handset on BASE to register, please start
again from Step 1 above.
NOTES:
•
You cannot register a handset if any other system
handset is in use.
•
Registration slots are full shows on the base
screen while you are doing Step 3 above.
9
Put Handset
on BASE
to register
Registering...
Please wait
Registering
handset...
HANDSET X
registered
HANDSET X
registered
Advertisement
Table of Contents
