Table of Contents
Advertisement
Getting started
Battery installation and charging
Install the battery as shown on page 7.
the battery, the screen indicates the battery status (see the table
below). If necessary, place the handset in the telephone base or
charger to charge the battery. For best performance, keep the
handset in the telephone base or charger when not in use. The
battery is fully charged after 16 hours of continuous charging.
See the table on page 31 for battery operating times.
If the screen shows Place in charger and
charge the handset without interruption
to give the handset enough charge to use the telephone for a
short time.
The following table summarizes the battery charge
indicators and actions to take.
Battery indicators
The screen is blank
or shows Place
in charger and
flashes.
The screen shows
Low battery and
flashes.
The screen shows
HANDSET X.
NOTE: If you are on a phone call in low battery mode, you hear four short
beeps every minute.
Battery status
The battery has no or
very little charge. The
handset cannot be used.
�attery has enough
charge to be used for a
short time.
�attery is charged.
6
�nce you have installed
flashes, you need to
for at least 30 minutes
Action
Charge without interruption
(at least 30 minutes).
Charge without interruption
(at least 30 minutes).
To keep the battery
charged, place it in the
telephone base or charger
when not in use.
Advertisement
Table of Contents
