Outside Air Kit Installation; Blower - Quadra-Fire Isle Royale Instructions Manual

Non-catalytic, top-load, wood heater

Hide thumbs Also See for Isle Royale:

Manual (32 pages)

Table Of Contents

Table of Contents

Included in Kit: 1 ﬂex ﬂange; 2 cable ties; oustide air

termination cap; mounting screws (Discard the remaining

parts).

Items Needed for Installation: 4 inch (102mm) diameter

ﬂex pipe in the length as required for your installation;

Phillips screwdriver; Silicone sealant; Drills and saws

necessary for cutting holes through the wall or ﬂooring

in your home.

. Remove all materials from packing box.

2. Mount the ﬂex ﬂange (with pipe ﬁtting extending out),

over the intake air opening at the rear of stove using the

four mounting screws supplied with kit.

3. Cut a 4 inch (102mm) minimum hole in the ﬂoor or wall

to accommodate outside air piping. Use 4 inch (102mm)

metal ﬂex or rigid piping to directly connect outside air to

the unit or into vented crawl space. (Do not put ﬂex into

a non-vented crawl space). If using ﬂex tubing attach

cable ties to secure tubing at both ends. Use the supplied

termination cap with a rodent screen. Seal between the

ﬂoor or wall and the pipe with silicone to prevent moisture

penetration.

The blower is shipped fully assembled and ready for installation.

Remove 3 Phillips head screws from rear of unit.

Using the Phillips head screws, attach blower to lower rear

of stove, as shown.

Plug blower cord into a grounded outlet. Do not remove

ground prong from plug. Route power cord to avoid heat

from the stove, or other damage. Do not route cord under

or in front of appliance.

Adjust the blower speed control to the desired speed.

ADJUSTING THE BLOWER SPEED CONTROL,*

If Necessary

NOTE: When the speed control is turned clockwise, it will click on

to high speed. Turn the speed control clockwise to decrease

the speed. At full clockwise, the blower should blow gently,

but should not stop.

With the unit plugged in, turn the speed control knob to slow

(full clockwise).

With a small screwdriver, adjust the blower speed by turning

the adjustment mechanism through the hole on the side of

the speed control.

Adjust the speed so the blower runs slowly, but does not stop.

Turn clockwise to slow the blower and counterclockwise to

increase the speed.

Page 16

Isle Royale Wood Stove