Table of Contents
Advertisement
2-4-3. Spot Out
Item
SPOT OUT
SPOT TYPE Select Full screen or Quad screen mode.
SPOT ON EVENT Enable/Disable display of the channel when an event is active.
SPOT EVENT
DWELL TIME
SEQUENCE Enable/disable sequential display of spot channel in full screen.
SEQ-DWEL TIME Set the dwell time for the spot channel display.(3-10sec)
SPOT CHANNEL Select a channel for spot monitoring using the mouse or the control
2-4-4. Motion Zone Setup
Select MOTION ZONE using the control button (
ZONE using the control button (
If FULL ZONE is selected, the motion setting screen is not displayed. Only set the level of sensitivity for
MOTION SENSITIVITY.
FULL ZONE: The motion sensor is active on the whole screen.
PARTIAL ZONE: The motion sensor is active in the set detection frame.
Select the sensor detection position using the control button (
Spot Out 1: from 1 channel to 4 channel
Spot Out 2: from 5 channel to 8 channel
Spot Out 3: for 9 channel
Spot Out 4: for 10 channel
Set the dwell time for the display of the event activated channel.
(3-10sec)
If select ON, spot channel selection screen is displayed.
◀ ▲ ▶ ▼
button (
) on the remote control and press OK button.
◀ ▲ ▶ ▼
◀ ▲ ▶ ▼
). And press the SEL button.
Description
) and select either PARTIAL ZONE or FULL
◀ ▲ ▶ ▼
32
) and press the SEL button.
Advertisement
Table of Contents
