Removing Handles; Materials Needed; Leveling - Maytag MCS 67002813 Owner's Manual

Installing handles
If installing handles for the first time, the
fresh food handles can be located within
the fresh food section. The handle trim
will be located in the literature pack.
➢ Remove two
1 " hex nut screws from
⁄
4
bottom of refrigerator and freezer
door.
➢ Align door handles with top and bot-
tom sets of door clips, and slide down
until screw holes on bottom of handles
match with door screw holes.
➢ Insert
1 " hex nut screws previously
⁄
4
removed into screw holes at bottom of
handle section.
➢ Snap trim over bottom portion of han-
dles and retainers on bottom of door.

Removing handles

Removing handles may be necessary
when transporting unit through tight
spaces.
➢ Remove bottom portion of handles with
a very small flat-blade screwdriver.
IMPORTANT: Wrap blade of screwdriver
with masking tape to avoid damaging
unit.
➢ Remove two handle base screws.
➢ Pull handle up and out to release from
unit. Fit may be tight.
Leveling your
refrigerator
CAUTION
➢ Protect soft vinyl or other flooring
with cardboard, rugs or other pro-
tective material, prior to moving
refrigerator.
➢ To avoid damage or breakage to
adjusting bolt, do not use power
tools to correct leveling.
➢ DO NOT adjust unit to be any
shorter than 68 " tall (minus hinge
1 ⁄
2
and cap). Doing so may damage
underside components.

MATERIALS NEEDED:

• 3 " hex head driver
⁄
8
• Level
➢ Remove toe grille and bottom hinge
covers (see previous instructions).
➢ Turn both front adjustment screws (A)
clockwise to raise and counterclock-
wise to lower.
A
➢ Turn both rear adjustment screws (B)
clockwise to raise and counterclock-
wise to lower.
B
➢ Check with level to verify
back for proper door closure.
• If unit is aligned and stable, replace
toe grille and hinge covers.
1 " tilt to the
⁄
4
4