Dish Network; Single Satellite 119; Dish 500 - VuQube VQ3000 Operating Instructions Manual

DISH NETWORK ANTENNA CONFIGURATION
1. On the VuQube controller, press and release the ON button.
Wait for the status light to flash orange, and then flash
green or red.
2. Press and release the ON button 20 times.
The status light starts rapidly flashing green and red.
3. Press and hold the
The status light will turn orange for 1 second, and then start flashing
green or red.
4. Press OFF.
5. After you have successfully configured the antenna, you must configure
your receiver for mobile use. To configure your receiver,
GO TO PAGE 12 AND RUN THE CHECK SWITCH.
1. On the VuQube controller, press and release the ON button.
Wait for the status light to flash orange, and then flash
green or red.
2. Press and release the ON button 12 times.
The status light starts rapidly flashing green and red.
3. Press and hold the
The status light will turn orange for 1 second, and then start flashing
green or red.
4. Press OFF.
5. After you have successfully configured the antenna, you must configure
your receiver for mobile use. To configure your receiver,
GO TO PAGE 12 AND RUN THE CHECK SWITCH.

Single Satellite 119

button for 4 seconds.
DISH 500 (satellites 110, 119)
button for 4 seconds.
Page 7