Table of Contents
Advertisement
IMPORTANT: There must be a clear "line of sight" to the southern sky. Mountains, buildings, trees,
telephone poles, etc. can all block the satellite signal from reaching the dish.
The distance driven since last performing a search may affect how long it takes the
VuQube to find the satellite.
Satellite TV and receiver technology are constantly changing. If you experience difficulty
go to www.kingcontrols.com or contact the King Controls Service Department at
(800) 982-9920.
1. Turn on TV and Receiver. "Searching for Satellite" or similar will appear on TV screen.
2. On VuQube controller, press and hold the
ON button for 3 FULL SECONDS.
Power light turns steady GREEN.
STATUS LIGHT
a) flashes a variety of colors
for about 30 seconds
b) RED-flashing
c) GREEN-flashing (may start
flashing RED again)
d) GREEN-steady
3. When the status light is steady green, select a channel or the program guide to view your
programming. Enjoy! (DO NOT TURN THE VUQUBE OFF IF USING THE AUTOMATIC
SATELLITE SWITCHING FEATURE.)
Note: If the status light is steady GREEN and your programming does not appear, press the reset button on your
DIRECTV receiver. If using Dish Network, hold the receiver power button in for 10 seconds to reset your
receiver. Consult your receiver owner's manual for further details. (Note that it may take several minutes
for the guide to re-download.)
When receiver reset is complete and the guide is downloaded, select a channel or the program guide to
view your programming.
Page 14
OPERATION
SECTION 4
STATIONARY SEARCH
SYSTEM STATUS
unit performs self-diagnostic
search in progress
potential satellite found
satellite(s) found and search is complete
Advertisement
Table of Contents
