DISH NETWORK ANTENNA CONFIGURATION-continued
DISH 1000 HD (satellites 110, 119, 129)
1. On the VuQube controller, press and release the ON button.
Wait for the status light to flash orange, and then flash
green or red.
2. Press and release the ON button 20 times.
The status light starts rapidly flashing green and red.
3. Press and hold the
The status light will turn orange for 1 second, and then start flashing
green or red.
4. Press OFF.
5. After you have successfully configured the antenna, you must configure
your receiver for mobile use. To configure your receiver,
GO TO PAGE 12 AND RUN THE CHECK SWITCH.
DISH 1000a HD (satellites 61, 110, 119)
1. On the VuQube controller, press and release the ON button.
Wait for the status light to flash orange, and then flash
green or red.
2. Press and release the ON button 16 times.
The status light starts rapidly flashing green and red.
3. Press and hold the
The status light will turn orange for 1 second, and then start flashing
green or red.
4. Press OFF.
5. After you have successfully configured the antenna, you must configure
your receiver for mobile use. To configure your receiver,
GO TO PAGE 12 AND RUN THE CHECK SWITCH.
button for 4 seconds.
button for 4 seconds.
Page 9