Stirrer Assembly - GE DVM1950 Technical Service Manual

Power Saver Battery
The rechargeable power saver battery is mounted
in a plastic holder that is mounted to the grille, just
above the control panel assembly. (See Control
Panel Assembly.)
The power saver battery is connected to the smart
board at CN901.
The power saver battery snaps into the plastic
holder, which, in turn, snaps onto the grille.
The power saver battery output is approximately 2.5
VDC.
Holder
Battery
– 24 –

Stirrer Assembly

The stirrer assembly consists of a blade, pin, and
cover. The blade is air driven and rotates on a shaft
embedded in the stirrer cover. The stirrer assembly
is located at the top of the oven cavity.
To remove the stirrer assembly:
1. Disconnect power from the microwave oven and
open the door.
2. Gently pry up on the plastic retainer using a
small, fl at blade screwdriver and remove. Turn
the stirrer cover counterclockwise to open. The
stirrer assembly will then drop down. To reinstall,
place in position and turn clockwise to lock in
place.
Stirrer Assembly
Retainer