Table of Contents
Advertisement
Taurus Super-S Combo
If the system
doesn't recogn
ise
the drive, turn on
the power first,
before connectin
g
the interface cable
or connect the
device before
booting your
Operating Sys
tem.
Installation on a Macintosh
Before connecting the device, setup the RAID mode using the
selector switch at the back of the enclosure.
If the drives have been pre-installed and setup already, you do
not need to change anything, unless you prefer a different
setup.
Turn on your computer and start Mac OS.
Connect the Taurus and turn it on.
No driver installation required.
The external drive will mount and show up on your desktop.
Note: For more info about formatting, see "Partitioning &
Formatting".
Remove Procedure
For the safe removal of your drive and to assure that no data is
lost, always follow the correct unplug procedure.
Drag the external hard drive icon into the trash bin
Turn off your device
Page 10 / Chapter 3 - System Set Up
User Guide
Advertisement
Table of Contents
