Installation On A Pc - Taurus Super-S Combo User Manual

Taurus Super-S Combo
If the system
doesn't recogn ise
the drive, turn on
the power first,
before connectin g
the interface cable
or connect the
device before
booting your
Operating Sys tem.

Installation on a PC

Before connecting the device, setup the RAID mode using the
selector switch at the back of the enclosure.
If the drives have been pre-installed and setup already, you do
not need to change anything, unless you prefer a different
setup.
 Turn on your Computer and start Windows.
 Connect the Taurus and turn it on.
 Let Windows search and install the driver automatically.
 Open "My Computer" to see your external hard drive.
Note: For more info about formatting, see "Partitioning &
Formatting".
Remove Procedure
For the safe removal of your drive and to assure that no data is
lost, always follow the correct unplug procedure. Otherwise, an
error message will appear.
 Click on the taskbar icon for external hardware
 Choose your external hard drive and confirm to remove it
Page 9 / Chapter 3 - System Set Up
User Guide