Troubleshooting - Dish Network Remote Control User Manual

T
ROUBLESHOOTING
What's
Happening
While doing
remote control
procedure, the
remote control
stops working.
When you press
a button on the
remote control,
the equipment
doesn't do what
you expect.
Your picture is
snowy (or blue
or black).
Your remote
control isn't
working
18
What's Wrong
• If you don't press
a button for 20
seconds in a
programming
sequence, the
remote shuts off its
programming
function.
• Maybe you didn't
set the remote to
the mode for the
equipment you
want to control.
• Maybe you're not
pointing the
remote control
right at the TV (or
other equipment).
• Maybe the remote
control is missing
batteries, maybe
you put the
batteries in the
remote the wrong
way, or maybe the
batteries are weak
or dead.
• Maybe you didn't
set up the remote
to control the
equipment.
• You have
accidentally
changed the
channel on your
TV.
• The remote control
is in the wrong
mode.
• You might be
using the wrong
remote control
(TV1 or TV2).
• Your batteries are
worn out.
What You Can Do
Start over again.
• Press the correct mode button to set the
remote to the mode for the equipment
you want to control.
• The remote control uses IR signals to
control all equipment except for the
receiver (when using UHF). IR signals
travel only 40 feet or less, and can't go
through walls or other solid objects.
You must point the remote control right
at the equipment, with no objects to
block the signal path.
• If the batteries are missing or dead, put
fresh AAA-size batteries in. If the
remote has fresh batteries, check
whether you put them in the right way.
If you didn't, take them out and put
them in the right way.
• Make sure you set up the remote
to control all the equipment you want
to use. See Program the Remote to
Control Your TV on page S-2 and
Programming for Other Equipment on
page 2.
• Make sure your TV (and VCR, if
connected) is tuned to the correct
channel. Also try using the Recover
button as described on page S-3.
• Make sure the remote control is in the
correct mode. For example, if you want
to use the satellite receiver, put the
remote control in
Remote Control Modes on page 1).
• Make sure you are using the correct
remote control (TV1 or TV2) for your
locations (multi-room receivers only).
• Change the batteries as described on
page S-1.
mode (see
SAT