Installation - Carrier 50HX Installation, Start-Up, And Operating Instructions Manual

UNIT ELECTRICAL CHARACTERISTICS
50HX036 208/230-1-60
50HX042 208/230-1-60
50HX048 208/230-1-60
50HX060 208/230-1-60,
holes are provided in base rails as shown in Fig. 7, See Detail "A"
or "B-B". Refer to rigging instructions on unit.

INSTALLATION

1. Position the lifting bracket assembly around the base of the
unit. Leave the top shipping skid on the unit to act as a
spreader bar. Be sure the strap does not twist.
2. Place each of the four (4) metal lifting brackets into the
rigging holds in the composite pan.
UNIT WEIGHT
lb.
316
316
359
373
Fig. 4— 50HX036-060 Unit Dimensions (without base rails)
CORNER WT
LB/KG
kg A B C
144 46/21 103/47 81/37
144 46/21 103/47 81/37
163 89/40 81/37 113/51
170 92/42 85/39 116/53
3. Tighten the ratchet strap unit tight. Lifting brackets should be
secure in the rigging holds.
4. Attach the clevis or hook of sufficient strength to hole in the
lifting bracket (See Fig. 7).
5. Attach safety straps directly to the field supplied rigging straps
or clevis clip. Do not attach the safety straps to the lifting
brackets.
6. Use the top of the unit as a spreader bar to prevent the rigging
straps from damaging the unit. If the wood top is not available,
5
CENTER OF GRAVITY
IN/MM
D X Y
86/39 21.2/539 20.4/520
86/39 21.2/539 20.4/520
76/35 19.7/500 20.5/522
80/36 19.6/499 20.6/523
C95005
Z
13.6/347
13.6/547
15.0/381
15.0/381