Table of Contents
Advertisement
RF Programmer
Selecting Programmable Features
1. Press the POWER button to turn the system ON.
2. Once powered up the MENU screen will be displayed.
3. Use the UP & DN arrows to scroll through the programmable features. Once you locate the desired
>
feature to change, press the
arrow to advance to the next screen. You should see the default setting
of the system
4. Press the SET button to scroll through the available settings. Once the desired setting is shown on
<
the screen, press the
to return to the feature chart selectable options or press SEND to transmit to
the system you are installing.
NOTE: You must access the RF receive bank on Option programming to SEND the selected information
to the CA 660, please refer to the programming section on the next page.
Using the M1 function
The RF Programmer has a memory function that will allow you to store the 4 most common feature
settings.
Once you have selected the settings that you want to store press and hold M1 button for 3 seconds. A
menu will appear which will allow you to select the memory bank you wish to save the desired feature
setting into.
Press the SET button to store the setting into memory. The menu will display "Write to memory X"
To retrieve a stored feature setting, press and release the M1 button. A menu will appear that will allow
you to select the desired memory bank.
Press SET to retrieve the desired stored memory bank. The menu will display "Read from memory X"
Advertisement
Table of Contents
