Code Alarm CA- 550 Installation Manual page 17

3. 6 PIN REMOTE START HARNESS CONT.
Active Output (18 AWG) (BLUE/BLACK)
The Ignition 3 output wire provides a ground output when the remote start function is activated and remains
until 4 seconds after the remote start is shutdown. The Ignition 3 output wire can be used for several
functions listed below. If this wire will be used for multiple application's a 1 amp diode is required in-line
with the stripe facing the control module.
Factory transponder (coded key) bypass.
General Motors VATS bypass, see the diagram below. Use Code Alarm part HDRLY (an SPDT relay, not
included).
GM VATS
Fused +12 Volt
Battery Source
Ignition 3 output, see the diagram below. Use Code Alarm part HDRLY (an SPDT relay, not included).
Accessory 2/3 output, see the diagram below. Use Code Alarm part HDRLY (an SPDT relay, not included).
Ignition 3 Output
Fused +12 Volt
Battery Source
87
Jump To PINK
87a
Ignition Output
86
Wire From
30
Control Module
To Vehicle's2nd or 3rd
Ignition Wire
Matching Value
Resistor
87
BLUE/BLACK ActiveOutput
87a
Wire
86 85
30
BLUE/BLACK ActiveOutput
Wire
85
Ignition Switch
X CUT
VATS Control Module
Accessory 2/3 Output
Fused +12 Volt
Battery Source
87
Jump To ORANGE
87a
Accessory Output
86
Wire From
Control Module 30
To Vehicle's2nd or 3rd
Accessory Wire
BLUE/BLACK ActiveOutput
Wire
85