Table of Contents
Advertisement
Switch Module Management
Switch Module Management
McDATA Embedded Web Server
McDATA Element Manager
Command Line Interface
Simple Network Management Protocol
File Transfer Protocol
1-8
McDATA 4416 Fibre Channel Switch Module Installation Guide
The switch supports the following management tools:
•
McDATA Embedded Web Server
•
McDATA Element Manager
•
Command Line Interface
•
Simple Network Management Protocol
•
File Transfer Protocol
McDATA Embedded Web Server is a graphical user interface that provides
both fabric and switch module management functions. Because McDATA
Embedded Web Server resides in the switch firmware, no installation is
needed. You can run one instance of the McDATA Embedded Web Server at a
time by opening the switch IP address with an internet browser. Refer to the
McDATA Switch Module Management Guide for information about the
McDATA Embedded Web Server.
McDATA Element Manager is a subset of the McDATA Embedded Web
Server and enables you to manage a single switch through EFCM. To open
McDATA Element Manager through EFCM, you must install the Element
Manager (PFE) key on the switch module. For information about McDATA
Element Manager and its capabilities, refer to the McDATA Switch Module
Management Guide.
The command line interface (CLI) provides monitoring and configuration
functions by which the administrator can manage the fabric and its switches.
The CLI is accessible over an Ethernet connection. Refer to McDATA 4416
Command Line Interface Guide for more information.
SNMP provides monitoring and trap functions for the fabric. The switch
module firmware supports SNMP versions 1 and 2, the Fibre Alliance
Management Information Base (FA-MIB) version 4.0, and the Fabric Element
Management Information Base (FE-MIB) RFC 2837. Traps can be formatted
using SNMP version 1 or 2.
FTP provides the command line interface for exchanging files between the
switch module and the management workstation. These files include
firmware image files, configuration files, and log files. Refer to the McDATA
4416 Command Line Interface Guide for an example of using FTP to transfer
configuration backup files.
Advertisement
Table of Contents
