Functional Description; Product Specifications; Unpacking; Tools Needed - Delta 31-482 Operating Instructions And Parts Manual

®
The DELTA Oscillating Edge Sander is a professional-grade tool designed for both straight and angled edge-face
sanding as well as contour sanding. It is capable of sanding in either the vertical or horizontal plane. Your DELTA
Oscillating Edge Sander comes with a 100 grit sanding belt and is mounted on a cabinet base that provides ample
storage space for accessories. This tool is powered by a 1-1/2HP, 120/240V induction motor that drives the sanding
belt and provides an oscillation stroke of ½" at a rate of 108 strokes per minute.
Model
Fence (hxL)
Abrasive Belt Size (wxL)
dust Chute diameter
Contour Sanding Table Size
Table Size (Lxw)
Table Tilt
Motor
Sanding Belt Speed
Oscillation Stroke
Oscillations per Minute
Overall dimensions (Lxwxh)
Net weight, approximate
Shipping weight, approximate
Your Oscillating Edge Sander comes packed in a single container. Open the shipping container and check that all
parts are present and in good condition:
dESCRIPTION (QUANTITY)
Front Cabinet Panel with Door (1)
Rear Cabinet Panel (1)
Side Cabinet Panels (2)
Cabinet Shelf (1)
Rubber Feet (4)
Lock Knob - 35mm (1)
Lock Knob - 20mm (1)
Lock Knob - 12mm (2)
Contour Sanding Table (1)
Drum Guard/Dust Port (1)
Compare the contents of your container with the parts list to make sure all
parts are present and intact. Report any missing or damaged parts to your
distributor. Prior to tool assembly and use, read this manual thoroughly
to familiarize yourself with proper assembly, maintenance and safety
procedures.

FUNCTIONAL dESCRIPTION

PROdUCT SPECIFICATIONS

31-482
4" x 24"
6" x 89"
4"
9-3/4" x 11-3/4"
10" x 29-3/4"
0-90°
1-1/2hP, 120/240V, 1Ph, 60hz, TEFC
3900 FPM
½"
108
51"x26.5"x20"
218
233

UNPACKINg

Owner's Manual (1)
Warranty Card (1)
Table Assembly (1)
Back Stop Bracket (1)
Belt Tension Handle (1)
Belt Tracking Tool (1)
Miter Gauge Assembly (1)
Sanding Belt (1)
Mounting Bracket (1)
7

TOOLS NEEdEd

FOR ASSEMBLY
• Two 12mm wrenches or
sockets
• 10mm wrench or socket
• Flat head screw driver
• Phillips head screw
driver
• Rubber mallet
hARdwARE
5/16" x 5/8" Screws (4)
5/16" Flat Washers (22)
5/16" Hex Nuts (12)
5/16" x 5/8" Hex Cap Bolts (8)
5/16" x 1-1/4" Hex Cap Bolts (2)
5/16" Flat Washers (4)
5/16" Lock Washers (10)
M5x10 Pan Head Screws (2)
M5 Flat Washers (2)
M5 Lock Washers (2)
1/4" x 5/8" Hex Cap Bolts (5)
1/4" Flat Washers (5)
1/4" Lock Washers (5)
10-24 x 3/4 Socket Head Cap
Screws (2)
Pan Head Screws (3)
T-Nuts (2)
®