Troubleshooting; Please Do Not Return This Product To The Store - Bissell CleanView Zing Easyvac Compact User Manual

T
roubleshooting
Vacuum cleaner won't run
Possible Cause
1. Vacuum cleaner is not plugged in
2. Power button is not pressed down
Vacuum cleaner won't pick up or low suction
Possible Cause
1. Tools, hose and/or extension wands are blocked
2. Filters are dirty
3. Dirt cup is full
4. Hose connector not securely attached to suction inlet
5. Crack or hole in hose
6. Air flow regulator is set to open or minimum setting
7. Clog in the dirt cup
Visible dust escaping from vacuum
Possible Cause
1. Dirt cup is full
Visible dust escaping from vacuum continued
Possible causes
2. Filters missing or installed incorrectly
3. Filters are dirty
4. Hose is blocked
5. Hose connector not securely attached to
suction inlet
6. Crack or hole in hose
Other maintenance or service not included in the manual should be
performed by an authorized service representative.
Thank you for selecting a BISSELL product

Please do not return this product to the store.

10
w w w . b i s s e l l . c o m
Remedy
1. Check electrical plug
2. Press power button down
Remedy
1. Remove each part and check for
blockages
2. Check and clean or replace all filters
3. Empty dirt cup
4. Make sure hose connector is locked
into suction inlet
5. Check hose and replace if needed
6. Change to closed or maximum setting
7. Clear clog from dirt cup following
instructions above
Remedy
1. Empty dirt cup
Remedies
2. Check all filters for correct installation
3. Check and clean or replace all filters
4. Remove hose and check for blockages
5. Make sure hose connector is locked
into suction inlet
6. Check hose and replace if needed