Advertisement
and hold the trunk/key button to activate this trunk release output, or press and release the trunk/key button
two times within 2 seconds to activate the remote starter.
WARNING: Connecting the dark blue wire to the high current switched output of the trunk release
circuits and some remote start trigger inputs, will damage the control module.
Connect the dark blue wire to terminal 86 of a 30 A automotive grade relay, connect terminal 85 to a fused
+12 volt source and wire the remaining relay contacts to perform the selected function desired.
2 Green w/ Black Trace Wire: 300 mA Latched Channel 4 Output
The Green w/ Black Trace wire supplies a 300 mA switched output whenever channel four of the receiver is
accessed. Pressing the pre-programmed transmitter button(s) will access channel four and will remain
active, for up to 20 seconds, as long as the transmitter button(s) is held.
This is a low current output and must be connected to a relay to supply power to the device you intend to
control.
Note:
This wire also can be used for defrost activation as dictated by the setting of feature # 1 of Bank 3.
Anytime the vehicle is running under control of the Remote Start and Channel 4 is activated, then
dependent on the selection of this feature, Green/Black will be activated as a pulse for 1 second, or
for 10 minutes. Note this wire will not operate when the vehicle is running under the power of the
ignition key, only while under the control of the remote start or if not used for defrost then an output
will occur as indicated above.
WARNING: Connecting the green/black to a high current circuits, will damage the control module.
Connect the green/black to terminal 86 of a 30 A automotive relay.
Connect terminal #85 of the relay to a fused + 12 volt source, and wire the remaining relay contacts to
perform the selected function of channel 4.
3 Lt Blue/Green Wire : Delayed 300 mA PULSED OUTPUT / CHANNEL 5
The light blue/green wire pulses to ground via an independent RF channel from the keychain transmitter. This
is a transistorized, low current output, and should only be used to drive an external relay coil.
WARNING: Connecting the light blue/green to a high current circuits, will damage the control module.
Connect the green/black to terminal 86 of a 30 A automotive relay.
Connect terminal #85 of the relay to a fused + 12 volt source, and wire the remaining relay contacts to
perform the selected function of channel 5.
4 Lt Blue/Black Wire : (-) 300mA Selectable Output Channel 6
The light blue/black wire pulses to ground via an independent RF channel from the keychain transmitter. This
is a transistorized, low current output, and should only be used to drive an external relay coil.
WARNING: Connecting the light blue/black to the high current circuits, will damage the control module.
Connect the light blue/black to terminal 86 of a 30 A automotive relay.
Connect terminal #85 of the relay to a fused + 12 volt source, and wire the remaining relay contacts to
perform the selected function of channel 6.
5 Blue/Red Wire : Delayed 300 mA PULSED OUTPUT / CHANNEL 7
The blue/red wire pulses to ground via an independent RF channel from the keychain transmitter. This is a
transistorized, low current output, and should only be used to drive an external relay coil.
12
128-8784b
12 of 28
Advertisement
