Delta 36-550 Instruction Manual page 13

ASSEMBLING
MITER GAGE HOLDER
1. DISCONNECT MACHINE FROM POWER SOURCE.
2. Assemble spring clip (E) Fig. 26, to the miter gage
holder (A) as shown using a M4x10mm pan head screw
(F), 3/16" lockwasher and M4 hex nut. NOTE: Hex nut
(G) Fig. 27, will fit into the recess at the back of the miter
gage holder (A) to keep spring clip (E) Fig. 26, secured to
the miter gage holder.
3. Assemble the miter gage holder (A) Fig. 28, to the left
side of the saw cabinet using the four M4.2x10mm pan
head screws (B) Fig. 29, and 3/16" washers (C) from
inside saw cabinet.
4. Fig. 30, illustrates the miter gage (D) inserted into the
miter gage holder when not in use.
C
B
Fig. 29
E
F
A
13
Fig. 26
G
Fig. 27
Fig. 28
D
Fig. 30
A
A