How To Change The Address - Dish Network Digital PVR User Manual

H C
OW TO
If your receiver does not respond to this remote, it may have a different
address. To make sure both the receiver and the remote have the same
address, do this.
1. Open the Important System Information menu.
To do this, press the receiver front panel
POWER button to turn the receiver off, and
then press the receiver front panel SYS INFO
or INFORMATION button. Make sure the TV
is turned on. This will open the Important
System Information menu. Look for the
remote address.
Note: If your receiver does not have a front panel
SYS INFO or an INFORMATION button, make
sure the TV is on, and pull the Smart Card out of
the receiver to open the Important System
Information menu.
2. Press and hold the SAT mode button about three
seconds, until all the mode button backlights
come on, and then release the SAT button.The
SAT mode light will start flashing.
3. Use the number pad buttons to enter the number
listed after Remote Address on the Important
System Information screen. The SAT mode
button backlight turns off after you enter each
digit, and then comes on again.
4. Press the POUND (#) button. If the address you
entered is valid for the remote control, the SAT
mode button backlight flashes three times.
113737
HANGE THE

How to Change the Address

A
DDRESS
Page 23