Dish Network Digital PVR User Manual page 21

3. Press and hold the mode button for the device
you want the remote to control, for about three
seconds. When all the other mode button
backlights come on, release the mode button. It
will begin flashing.
Note
The first time you program AUX mode,
:
you may see the TV Mode button light up. This is
to be expected and does not mean there is
anything wrong with the remote.
4. Only for the AUX mode, use a number pad
button to enter a prefix for the device: 0 is for a
second TV, 1 is for a second VCR and 2 is for a
cable box, amplifier or tuner.
5. For any mode, use the number pad buttons to
enter a device code from the table.
6. Press the POUND (#) button. If the code is
valid, the mode button backlight flashes three
times.
7. Press the POWER button to test if the code
works for the device. If the code works, the
device should turn off.
8. Turn the device back on and try some other buttons to make sure
they work. Sometimes, the POWER button will work but other
buttons do not. If the code works for other buttons, stop here.
9. If the code you entered does not work, repeat steps 3 through 8
with another code from the tables.
113737
Remote Control Procedures
For example
or:
or:
Page 19