AOpen AX4SG MAX II Easy Installation Manual page 3

1. Installing CPU
This socket supports FC-PGA2 package CPU, which is the latest CPU package
developed by Intel. Other forms of CPU package are impossible to be fitted in.
CPU socket lever
Socket Pin 1
Golden Cut Edge
2. Installing CPU & System Fans
Plug in the CPU fan cable to the 3-pin CPUFAN connector. If you have chassis fan,
you can also plug it in SYSFAN1 or SYSFAN2 connector.
GND
+12V
SENSOR
SYSFAN2 Connector
1. Pull up the CPU socket lever and up
to 90-degree angle.
2. Locate Pin 1 in the socket and look
for a (golden) cut edge on the CPU
upper interface. Match Pin 1 and
cut edge. Then insert the CPU into
the socket.
3. Press down the CPU socket lever
and finish CPU installation.
Note: If you do not
match the CPU socket Pin 1
and CPU cut edge well, you
may damage the CPU.
GND
+12V
SENSOR
SYSFAN1 Connector
GND
+12V
SENSOR
CPUFAN Connector
Note: Some CPU fans
do not have sensor pin so
they cannot support fan
monitoring.
3. Installing Memory Modules
DIMM slots are designed in Navy Blue and Electronic Blue which are very easy to
recognize. Insert the module straight down to the DIMM slot with both hands and
press down firmly until the DIMM module is securely in place.
Tab
4. Connecting IDE and Floppy Cables
Connect 34-pin floppy cable and 40-pin, 80-wire IDE cable to floppy connector FDD
and IDE connector. Be careful of the pin1 orientation. Wrong orientation may cause
system damage.
Pin 1
FDD Connector
Pin 1
Key
Note: The tabs of
the DIMM
close-up to hold the
DIMM in place when the
DIMM touches the slot's
bottom.
Secondary Secondary
Master (3rd)
Slave (4th)
Pin 1
Primary Primary
Master (1st)
Slave (2nd)
ATA 66/100 IDE
Connector
slot will
IDE 2 (Secondary)
IDE 1 (Primary)