Digital Direct; Rec Mute Function; Fade-In And Fade-Out - Tascam CD-RW750 Owner's Manual

To enable or disable automatic track division:
1
With a recordable disc inserted, and with the
unit in record ready mode, press the
key ( or ) repeatedly until
9 6
is shown, where
A_Track>XX
or .
ON OFF
2
Turn the
MULTI JOG
keys to change the value to
SKIP I
.
OFF
The indicator at the top right of the
A-TRACK
display lights when the auto track function is
enabled.
Automatic track division can be turned on or off
while recording is taking place.
NOTE
When recording certain types of material (e.g. certain
types of classical music or spoken word) through the

Digital direct

As mentioned earlier, the digital direct mode
bypasses some of the input circuitry of the CD-
RW750 (the frequency converter and the digital level
control) to write directly to the disc.
To enable or disable digital direct recording:
1
Ensure that the input source is set to
(either or
COAXIAL OPTICAL
2
Press the
DIGITAL DIRECT
only). The display shows
where is or
XX ON OFF

Rec mute function

The rec mute function allows instant cut-off of the
input signal, and records four seconds of silence on
the disc.
1
While recording is in progress, press the
key .
MUTE G
The display shows
REC MUTE
stop displaying the current level and the moni-
tored sound is cut.

Fade-in and fade-out

To provide smooth beginnings and endings to
recorded tracks, the unit provides fade facilities.
Fade-ins are from –" (silence) to the set input level
("Input selection" on page 18) and fade-outs go from
the current input volume to silence.
MENU
may be
XX
control or use the
B
or
ON
DIGITAL
).
key (main unit
5
D_Direct XX
.
REC
, the meters
analog or non-DAT/CD/MD digital connections, since
the track divisions are determined by relative silence, it
is possible that spurious track divisions will be inserted.
Under these conditions, it may be better to use manual
track division (see below).
However, if recording through a DAT/MD/CD digital
connection, the track number will be incremented only
when a track division signal is received, followed by a
rise in volume.
level Track start signal
received
S_LVL
3
Press the
DIGITAL DIRECT
between and
ON OFF
When digital direct recording is enabled, the
indicator in the display flashes slowly.
DIGITAL
NOTE
As mentioned earlier, the digital direct feature bypasses
the frequency converter. Recording is therefore only
possible from sources recorded with 44.1 kHz sampling
frequency.
2
After about four seconds, the unit enters
record ready mode.
NOTE
This function is only available from the remote control
unit. It is not possible to use this function with the main
unit only.
The fade-in and fade-out times can be set indepen-
dently in increments of one second, from 1 second to
24 seconds.
TASCAM CD-RW750 Owner's Manual
4 – Recording
Track incremented
time
key to toggle
.
23