Edimax Wireless Broadband Router User Manual page 40

Channel Number
Associated Clients
WLAN MAC
Clone MAC
MAC address
Set Security
Click <Apply> at the bottom of the screen to save the above
configurations. You can now configure other advance sections or start
using the router (with the advance settings in place)
11 T he channel used by the wireless LAN. All
devices in the same wireless LAN should use
the same channel.
Click "Show Active Clients" button, then an
"Active Wireless Client T able" will pop up. You
can see the status of all active wireless stations
that are connecting to the access point.
T his is the MAC address used by the Wireless
interface of this AP when it is in the station
modes.
Click the "Clone MAC" button will copy the MAC
address of your PC, that you are using to
configure the AP, to the WLAN MAC.
If you want to bridge more than one networks
together with wireless LAN, you have to set this
access point to "AP Bridge-Point to Point mode",
"AP Bridge-Point to Multi-Point mode" or "AP
Bridge-WDS mode". You have to enter the
MAC addresses of other access points that join
the bridging work.
Click the "Set Security" button, then a "WDS
Security Settings" will pop up. You can set the
security parameters used to bridge access
points together here when your AP is in AP
Bridge modes. You can refer to section 4.3
"Security Settings" for how to set the
parameters.
39