CDV7 Series Gas Fireplace
ReMoTe wall MounTeD SwITCh
A remote wall switch and up to fifteen (15) feet of 18 Ga. wire
may be used with this appliance. Attach the wall switch in a
junction box at the desired location on the wall. Figure 40. Do
not extend beyond the wall switch wire length provided.
noTe: Extended lengths of wire may cause the fireplace not
to function properly. Longer length of wire is permitted if the
wire is made out of larger gauge (diameter) wire. Always check with local code.
PILOT
HI
TH
TP
TH/TP
Figure 42 -
Wiring Diagram for Wall Switch
ReMoTe wall SwITCh
Position the wall switch. Do not extend beyond the 15 feet
of wire.
opTIonal DC ReMoTe SySTeMS
See section entitled Hearth Mount in the Millivolt hand held
remote instructions supplied with the remote.
1. Using a flat head screw driver, bend the "remote" tabs
up from the bottom of the fireplace. Figure 43
. Follow the instructions on remote control to snap the
remote cover plate to the remote receiver
3. Connect the wire terminal from the remote receiver.
Figure 42
4. Use the screws that came with the remote control to
mount the remote receiver cover to the bent up "remote"
tabs. Figure 43
8
ON
RS
OFF
FP1980
Dv wiring diagram
'Remote' Tabs
Remote Control
Receiver
Figure 43 -
Optional Control Location
eleCTRICal InSTallaTIon
Do not connect wall switch to (110 V)
circuit.
OPTIONAL REMOTE
WALL SWITCH
OPTIONAL REMOTE
CONTROL RECEIVER
Blower Speed
Control
FP2284a
CDV7 controls
ON
OFF
ON
OFF
FP84a
69D3011