Assembly And Setup - Razor Trikke E2 Owner's Manual

ASSEMBLY AND SET -UP
q Attaching the Stem
Tools Required: 5mm Allen wrench
1
Slide stem onto the front fork. Make sure throttle and brake cables are not touching the rotational corrector.
2
Align the front wheel with handlebars using a 5mm Allen wrench. Tighten bolts on collar clamp until collar clamp is secure.
4
Note: Make sure the cables/wires
are out of the way before inserting
the stem in the fork.
WARNING:
Failure
to properly tighten the collar
clamp may allow the handlebars
to dislodge while riding and may
cause you to lose control and fall.
When correctly tightened, the
handlebars will not rotate out of
alignment with the front wheel
under normal circumstances.
Note: The cable and wire
assembly from the handlebar
must not wrap around the stem
or handlebar. Sharp bends or
twisting of the brake cable can
cause the brakes to malfunction.