Cautions for Set-up
Prior to operation, read "For Safe Operation" carefully and observe the rules therein.
・
Use care when moving the printer. Never try carrying the printer alone.
・
Dropping it could cause injury or damage to other property.
Do not use or store the printer near fire, excessive moisture, in direct sunlight, near an air
・
conditioner or heater, or any other source of unusually high or low temperature or humidity, or
excessive dust.
Do not place the printer where chemical reactions occur, such as in a laboratory.
・
Do not set up the printer where there is salinity or corrosive gas in the air.
・
The printer must sit on a firm level surface where there is ample ventilation.
・
Do not put anything on the top of the printer.
・
Do not place the printer near a radio or television, and do not use the same wall outlet for the
・
printer and radio or television. Radio or television reception could be adversely affected.
Do not use a power voltage or frequency other than those specified.
・
Do not put anything on the power cord or step on it.
・
Do not drag or carry the printer by the power cord or USB cable.
・
Avoid plugging the power cord into an outlet with many loads.
・
Do not bundle the power cord.
・
Always grip the plug housing, not the cord, to plug/unplug the power cord.
・
Make certain the power is turned off before connecting/disconnecting the USB cable.
・
Avoid lengthening the signal cable or connecting it to any noise-producing device.
・
If it is unavoidable, use a shielded cable or twisted pair for each signal.
Place the printer near the outlet where the power cord can be unplugged easily to shut off
・
power.
Use an AC outlet that accepts a three-pronged plug. Otherwise, there may be danger of electric
・
shock.
Use the appropriate specified cord set.
・
Only use items that are certified safe according to the standards of the country where they are to
be used.
5