To Remove A Floppy Disk Drive; To Insert Or Remove A Floppy Disk - HP 800 Installation Manual

C A U T I O N
C A U T I O N
Using OmniBook Disk Drives
Installing a Floppy Disk Drive

To remove a floppy disk drive

Always wait until all disk activity stops before ejecting a disk or unplugging a
cable. The light on the front of the floppy disk drive is on when the OmniBook
is reading from or writing to the floppy disk drive.
1. Squeeze the tabs on the large cable plug and hold firmly while pulling the plug
from the back of the floppy drive.
2. Squeeze the tabs on the small cable plug and hold firmly while pulling the plug
from the back of the OmniBook.

To insert or remove a floppy disk

Do not remove a floppy disk while the OmniBook is actively reading or writing
data. Wait until the floppy drive is done —otherwise, you could lose data or the
OmniBook could stop responding.
1. To insert a floppy disk, hold the disk with its face up and slide it into the floppy
drive slot until it clicks into place.
2. To remove the floppy disk, press the eject tab. (If you're using the F1059B
model, slide the eject switch on the top of the floppy disk drive to the rear.)
1-10
Press the eject tab to
remove the floppy disk.