Updating The Firmware (Bios And Bmc) - Fujitsu PRIMERGY BX620 S5 Operating Manual

Updating the firmware (BIOS and BMC)

Ê Connect the monitor, keyboard and mouse to the KVM blade on the rear of
the basic unit. You will find more information on this in the manual for the
basic unit.
Ê Press the KVM button (item 4 in
the server blade to switch the keyboard, mouse and monitor from the KVM
blade to the server blade.
Software preparation
Booting from the CD-ROM/DVD drive
Boot the relevant server blade from the ServerView Installation Manager CD to
install the operating system. To do this, you may need to change a number of
settings:
Ê Insert the ServerView Installation Manager CD in the CD-ROM/DVD drive
and press the On/Off switch (item 2 in
panel of the server blade.
Ê Press the KVM button (item 4 in
the server blade to switch the keyboard, mouse and monitor from the KVM
blade to the server blade. Wait a few seconds until the monitor is activated.
Ê Press [F2], when prompted, to call the BIOS Setup of the server blade.
Ê Select the Boot submenu in the BIOS Setup menu and enable Boot from CD-
ROM Drive.
Ê Press [ESC] twice and select Exit Saving Changes from the Exit menu.
After booting the server blade from the ServerView Installation Manager CD, the
startup screen is displayed.
5.4 Updating the firmware (BIOS and BMC)
All files that are required for updating the server blade components are available
at http://download.ts.fujitsu.com.
You can update both the firmware of the server blade BIOS and the firmware of
the server blade BMC.
I
BMC is the abbreviation for Baseboard Management Controller. The
BMC on the server blade collects management information and passes
it on to the management blade.
46
figure 7 on page
figure 7 on page
figure 7 on page
Operating Manual
Installation and operation
40) on the control panel of
40) on the control
40) on the control panel of
BX620 S5