Table of Contents
Advertisement
Configuring a Server Blade
This section describes how to switch the BX620 S5 Server Blade on and off
using the control panel when the basic unit is switched on.
The basic unit also allows you to switch the installed server blades on and off
using the control panel of the entire system as well as using the Web interface
of the management blade. You will find more detailed information on this in the
"PRIMERGY BX600 S3 Basic Unit" manual.
Switching the server blade on and off using the control panel
The basic unit must be switched on.
The server blade can be switched on and off as follows:
– To switch the server blade on, hold down the On/Off button on the server
blade (item 2 in
To switch the server blade off, hold down the On/Off button on the
server blade (item 2 in
– Set switch-on/off time
The server blade is switched on and off at the times defined in the
ServerView Operation Manager.
– After power failure
Once a server blade has been switched on, it will switch itself on again
automatically after a power failure (depending on the BIOS settings, see
"BIOS Setup" on page
5.3
Configuring a Server Blade
Server blades can be configured in various ways:
– Local installation with or without the ServerView Installation Manager.
– Remote installation, see the ServerView Installation Manager Remote
Installation section in the ServerView Installation Manager manual on the
ServerView Suite DVD 2.
– By importing clone images from a remote image repository to the desired
server blades (you will find more information on this in the RemoteDeploy
manual on the ServerView Suite DVD 2 (as of version 5.210)).
44
figure 7 on page
40).
figure 7 on page
49).
Operating Manual
Installation and operation
40) for 4 seconds.
BX620 S5
Advertisement
Table of Contents
