Lt2002 Cloning Procedure Troubleshooting - LG 32LH250H Setup Manual

Warning: Do not use the LT2002
installed in TV, or the Clone Programmer and the PPV
card will be damaged.
Reset Clone After Static Shock
After replacing exhausted batteries, or if the Clone
Programmer behaves strangely after a static shock, use a
paper clip or similar instrument inserted through the small
hole marked RESET to activate the internal reset switch
and restore normal operation. After a reset, check the real-
time clock setting. It may be necessary to reset the Clone
Programmer clock from a TV containing the correct time.
Clone Programmer Troubleshooting
Symptom
Clone Programmer
Clone copies setup in
less than 30 seconds.
Remote does not operate
clone.
LED does not blink.
Clone menu hard to read. Weak signal.
No time set.
Clone not working.
Clone scans channels
more than once.
Master and Other TVs
Cloning did not work.
Clone time disappeared.
New setup not present.
• After cloning operations are complete, unplug the LT2002 from the TV.
• If the TV does not display a picture on the TV (blank screen) after a few seconds, just change channels.
206-4118
Reference: LT2002 Cloning Procedure Troubleshooting
while any PPV card is
Possible Cause(s)
Not enough time to copy entire TV setup.
Wrong Installer Remote.
MPI cord not connected.
TV not turned ON.
Weak batteries.
Time not available.
Clone Programmer problem.
Clone should only scan channels once.
Procedure interrupted.
Different TV models.
Step(s) omitted or not performed.
Batteries were removed.
TV not reset.
Note
The LT2002 Programmer is designed to be used with TVs
containing the 221-01006 and later processors. Use with
earlier TV sets may give unpredictable results. Processors
used before the 221-01006-04 have a limited screen dis-
play capability. They cannot display entire screens as
shown in the quick setup instructions accompanying the
LT2002 Clone Programmer. Use the printed menu illustra-
tions on the quick setup sheet supplied with the Clone
Programmer as an aid to making your programming choic-
es. (Although the menus are not all displayed, the clone
functions all operate normally.)
Possible Solution(s)
Press RESET on Clone Programmer, redo Teach/Learn.
(Teach/Learn should take a minimum of one (1) minute.)
Only use an LG Installer Remote to operate Clone
Programmer with TV.
Connect MPI cord properly, and ensure good connection.
TV must be powered ON for Clone Programmer to work.
Install four (4) fresh AA high-quality alkaline batteries.
Connect TV to a reliable analog channel signal source.
Set time on a TV, and copy time to Clone Programmer.
Try a different LT2002 Clone Programmer.
Reset the Clone Programmer.
Try cloning again.
Wait until procedure complete message is displayed.
Cloning is only possible with identical model TVs.
Refer to pages 20 to 23, and make sure all tasks were
performed.
Batteries must remain installed to retain time settings.
Disconnect newly-cloned unit from power for five (5) sec-
onds.
39